Technical Data:

• Duceram Kiss is compatible with Duceram Plus ...
• CTE Duceram Kiss dentine : 13,0 m/m.K
• CTE range alloys : 13,8 - 15,4 m/m.K
• Firing temperature dentin 1+2 : 910 / 900 C
• Powder opaque for the Spray technique available
• ... but...to have absolutely color reliability, you have to work in one system, because the opaques and the dentines of Duceram Kiss are completely reworked and aligned of each other.

6 Good Reasons For Using Duceram Kiss:

1. Economic Efficiency
   • Reduced assortment
   • Only fast moving powders in the assortment
   • Fast firing cycles due to higher heating rate
   • No long term cooling in combination with concept alloys
   • Time saving during layering due to the 3 powders layering technique
   • Low investment for the Lab due to the small assortment and comparatively low entry costs
2. Save color-reproduction due to the optimized coloring of the opaques and dentins in correlation to the v-shades
3. Due to combining different characteristics into one powder, like we did for the Power Chromas, it was possible to make the assortment so small
4. Aesthetic
   • The opal incisal powders are completely reworked and patented
   • In the past the opal effect was generated by small grains of zirconium oxide. The new opal effect is produced due to an decomposition inside the porcelain
5. Processing Reliability:
   • By using classical high fusing veneering ceramics the opal effect is loosing his properties after several firing cycles
   • By using Duceram Kiss the opal effect is absolutely firing stable
6. DeguDent Kiss:
   • No long term cooling due to low CTE
   • High distortion resistance, hence ideally suited for extensive implant restorations
   • Fast firing cycles possible ( 80 C/min )
   • Light-colored oxide